sat pvac_threshold pvt Platesetter_3244 This is the level that the firmware uses to determine whether there is a plate covering the picker sucction cups. Used in some cases to determine if there is a plate on the picker. (Proximity sensor is primary sensor for determining if plate on picker or plate box empty.) The threshold should be set to the 2/3 point between the No_plate_on_picker vacuum value and the plate_on_picker vacuum value, and no higher than 5 below the plate_on_Picker value. Higher value implies higher vacuum. byte

60

0 to 255

cal Procedure for setting pvt on intranet.

../commands/pvac.xmlCommand: pvac

../nvs/sat_cal_uvt.xmlNVS: sat uvt

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:37:27 2008 PST http://techplanet.creo.com/docs/setpkrvac.pdfOther: Procedure for setting pvt